Supplied air respirator

technique.

Moderator: Hub

Supplied air respirator

Postby bill3337 » Thu Apr 19, 2012 4:43 am

Not quite sure where to post this topic, but looking to see what people are using for supplied air respirators. I've been using one of the low cost Tyvec type hoods, which is ok, but the polycarbonate flexible lense is now cracking and needs replacing and I find it very bulky and a real pain to paint with. I'd be most comfortable with a half mask (supplied air), but worry about the isocyante contamination around the eyes. I've seen some of the 3M full face piece series hard units like the 6000 series and the 7800 series and would like to get some reviews of these and any other recommended face masks. There doesn't seem to be a lot of choice or information out there, so maybe only a small percentage uses these air supplied systems? Thanks, Bill
bill3337
LPH-50
 
Posts: 3
Joined: Thu Aug 13, 2009 1:43 am

Return to Spraying

Who is online

Users browsing this forum: No registered users and 4 guests

cron