Air Gunsa AZ3HTE gun setup

and settings.

Moderator: Hub

Air Gunsa AZ3HTE gun setup

Postby eyecandy » Fri Oct 02, 2009 12:28 pm

Hub,

I was wondering if you could help me out with gun setup on the AZ3HTE with a 1.5mm tip. I am using it with RM Diamont DP20 primer, Base Coat and Clear. I went thru the instructions in the manual, did a test panel, but when I spray the primer on the parts it just seems to be too dry...

I was using a flat test panel and the parts are mostly curved (front and rear bumpers). Any help would be appreciated!!
eyecandy
LPH-50
 
Posts: 8
Joined: Sun Apr 20, 2008 2:39 am
Location: Pittsburgh, PA

Return to Spray gun selection

Who is online

Users browsing this forum: No registered users and 2 guests

cron